Cytotoxicity, inflammation, biomineralization, and immunoexpression of IL-1β and TNF-α promoted by a new bioceramic cement

Abstract Aim To evaluate the cytotoxicity, biocompatibility and mineralization capacity of BIO-C PULPO, and MTA. Methodology L929 fibroblasts were cultured and MTT assay was used to determine the material cytotoxicity on 6, 24, and 48 h. A total of 30 male rats (Wistar) aged between 4 and 6 months, weighing between 250 and 300 g were used. Polyethylene tubes containing BIO-C PULPO, MTA, and empty tubes were implanted into dorsal connective tissue. After the experimental periods (7, 15, 30, 60, and 90 days) the tubes were histologically analyzed using hematoxylin-eosin (H&E), immunolabeling of IL-1β and TNF-α, and von Kossa staining, or without staining for polarized light analysis. The average number of inflammatory cells was quantified; the mineralization assessment was determined by the area marked in μm2 and semiquantitative immunolabeling analyses of IL-1β and TNF-α were performed. Then, data underwent statistical analysis with a 5% significance level. Results It was observed that BIO-C PULPO and MTA presented cytocompatibility at 6, 24, and 48 similar or higher than control for all evaluated period. On periods 7 and 15 days, BIO-C PULPO was the material with the highest number of inflammatory cells (p<0.05). On periods 30, 60, and 90 days, BIO-C PULPO and MTA presented similar inflammatory reactions (p>0.05). No statistical differences were found between Control, BIO-C PULPO, and MTA for immunolabeling of IL-1β and TNF-α in the different periods of analysis (p<0.05). Positive von Kossa staining and birefringent structures under polarized light were observed in all analyzed periods in contact with both materials, but larger mineralization area was found with BIO-C PULPO on day 90 (p<0.05). Conclusion BIO-C PULPO was biocompatible and induced mineralization similar to MTA.

Initial inflammatory response after the pulpotomy of rat molars with MTA or ferric sulfate

Abstract Purpose To compare, both qualitatively and quantitatively, the inflammatory cells, vascular density and IL-6 immunolabeled cells present in the pulp after pulpotomy with white MTA versus 15.5% ferric sulfate (FS). Methodology Forty-eight mandibular first molars from 24 Wistar rats were divided into MTA or FS groups and subdivided according to the period after pulpotomy procedure (24, 48 and 72 hours). Four teeth (sound and untreated) were used as controls. Histological sections were obtained and assessed through the descriptive analysis of morphological aspects of pulp tissue and the quantification of inflammatory cells, vascular density and interleukin-6 (IL-6) expression. Data were statistically analyzed (p<0.05). Results The number of inflammatory cells was similar in both groups, being predominantly localized at the cervical radicular third. In the MTA group, increased inflammation was observed at 48 hours. Vascular density was similar in both groups and over time, being predominant in the medium radicular third. No correlation was found between the number of inflammatory cells and the vascular density. Pulp tissue was more organized in MTA-treated teeth. In both groups, a weak to moderate IL-6 expression was detected in odontoblasts and inflammatory cells. Comparing both groups, there was a greater IL-6 expression in the cervical radicular third of teeth treated with MTA at 24 hours and in the medium and apical thirds at 72 hours, while in the FS group a greater IL-6 expression was found in the apical third at 24 hours. Conclusion The MTA group presented better histological features and greater IL-6 expression than the FS group. However, no difference was observed between the groups regarding the inflammatory status and vascularization, suggesting the usefulness of FS as a low-cost alternative to MTA.

Comparison between calcium hydroxide mixtures and mineral trioxide aggregate in primary teeth pulpotomy: a randomized controlled trial

Abstract Objectives: To evaluate the effect of calcium hydroxide (CH) associated with two different vehicles as a capping material for pulp tissue in primary molars, compared with mineral trioxide aggregate (MTA). Methodology: Forty-five primary mandibular molars with dental caries were treated by conventional pulpotomy using one of the following materials: MTA only (MTA group), CH with saline (CH+saline group) and CH with polyethylene glycol (CH+PEG group) (15 teeth/group). Clinical and periapical radiographic examinations of the pulpotomized teeth were performed 3, 6, and 12 months after treatment. Data were tested by chi-squared analysis and a multiple comparison post-test. Results: The MTA group showed both clinical and radiographic treatment success in 14/14 teeth (100%), at all follow-up appointments. By clinical evaluation, no teeth in the CH+saline and CH+PEG groups had signs of mobility, fistula, swelling or inflammation of the surrounding gingival tissue. However, in the CH+saline group, radiographic analysis detected internal resorption in up to 9/15 teeth (67%), and inter-radicular bone resorption and furcation radiolucency in up to 5/15 teeth (36%), from 3 to 12 months of follow-up. In the CH+PEG group, 2/11 teeth (18%) had internal resorption and 1/11 teeth (9%) presented bone resorption and furcation radiolucency at all follow-up appointments. Conclusion: CH with PEG performed better than CH with saline as capping material for pulpotomy of primary teeth. However, both combinations yielded clinical and radiographic results inferior to those of MTA alone.